Search
No search results were found
No search results were found
Complete LED light bar kit including the Ledson Alfa21 Gen2 Powerboost, model-specific mounting bracket and Connect wiring kit. The package includes the key components needed for a clean and convenient installation at the vehicle's licence plate.
The Alfa21 Gen2 combines a wide and well-balanced Driving Beam pattern with the option of choosing between E-approved operation and Powerboost. In E-approved mode, the light bar reaches 1 lux at 463 metres. With Powerboost activated, the range increases to an impressive 790 metres at 1 lux.
The Alfa21 Gen2 offers two different output modes:
• E-approved mode according to ECE R112: 1 lux at 463 metres
• Powerboost: 1 lux at 790 metres
Powerboost is activated by removing the fuse located by the DTP/ATP connector. This provides the maximum lighting performance of the light bar. Please note that the light bar is not E-approved when Powerboost is activated.
The computer-designed Driving Beam reflectors produce an even, wide and long-range light pattern that enhances and complements the vehicle's existing high beams.
The beam has characteristics similar to a Combo Beam but is optimised to comply with applicable regulations when used in E-approved mode. A colour temperature of 5000K provides a neutral white light.
The kit includes a mounting bracket specifically designed for the Alfa21 Gen2. It allows for a discreet installation at the licence plate and is designed to match the mounting pattern used by common Formac licence plate holders.
The light bar also features sliding rear brackets and side mounting feet, providing flexibility when choosing the installation method.
Vehicles with halogen high beams:
Our quick-connect relay wiring solution with ready-made connectors can be used to connect the light bar to the vehicle's high beams without modifying the vehicle's original wiring.
Vehicles with LED or xenon high beams:
If the vehicle is equipped with factory-installed LED or xenon high beams, an XBB Dongle or Cannect Interface is also required to allow the vehicle's high beams and LED light bar to switch on and off together. The XBB Dongle is recommended for a simple wireless installation.
• Ledson Alfa21 Gen2 LED light bar
• Alfa21 Gen2 mounting bracket
• Connect wiring kit, 1 x 2-pin DTP
• Licence plate locking strip
• Bolts and screws for mounting the light bar to the included bracket
• Installation instructions
• Size: 21 inches
• Beam pattern: Driving Beam / high beam
• Range, E-approved mode: 1 lux at 463 m
• Range, Powerboost: 1 lux at 790 m
• Actual light output: 15,500 lumens
• Theoretical light output: 19,000 lumens
• Colour temperature: 5000K
• Width: 546 mm
• Height: 60 mm
• Depth: 54 mm
• Voltage: 12 V
• E-marking: ECE R112, ref. 50 (without Powerboost only)
• EMC approval: ECE R10
• Manufacturer: Ledson
• Warranty: 36 months
The DTP/ATP connector must not be cut. Cutting the connector increases the risk of moisture damage and will void the warranty.
Powerboost mode is not E-approved according to ECE R112.
